12V 7.0Ah Battery
Part# LS1024

This is a a spare battery for the Ossian LS® Liquid Sprayer, allowing the unit to last even longer in the field with the ability to quickly change batteries.

FULLY CHARGE BATTERY PRIOR TO FIRST USE

For proper field change and maintenance of battery, follow the visual instructions below.

BATTERY REPLACEMENT IN FIELD

1)   Unplug siphon hose from inlet port in back of tank compartment.

2)   Remove tank from unit prior to lifting orange hood.

3)   Lift orange cover from rear catch and pivot forward providing access to battery cover and battery compartment.

4)   With a Phillips screwdriver unscrew battery cover and rotate out of position to expose battery compartment.

5)   Gentrly slide battery upwards ou tof battery compartment, exposing the battery leads.

6)   Disconnect leads and remove drained battery.

7)   Carefully insert FULLY CHARGED battery into battery compartment.

8)   Connect battery leads from battery compartment to corresponding terminals on battery.

  • Connect Black Lead to Black Terminal
  • Connect Red Lead to Red Terminal

9)   Install battery into compartment using care not to pinch wiring harness and screw battery cover shut.

PROPER BATTERY CARE

Although the Ossian LS® is designed for winter operation, proper battery care is required to ensure the unit will continue to operate at peak performance. Failure to do so will dramatically shorten the life of your battery.

Fully Charge Battery Prior to First Use.
Recharge battery at end of each use for optimum performance.

1)   Locate charging port on operator’s left side of rear battery compartment tower.
If necessary, remove liquid tank and raise orange cover to aid in accessing port.

2)   Plug round end of battery charger into charging port on battery tower.

3)   Plug battery charger transformer into standard 110w outlet.

4)   LED on transformer will turn red when battery is below a full charge.

5)   LED on transformer will turn green when battery is fully charged.

6)   When battery is fully charged, disconnect battery charger from charge port and close cover.
Push rear of cover down so that it fits snuggly over battery cover.

WARNINGS

  • Reinstall terminal covers on battery if disconnected for any reason.

  • DO NOT FREEZE BATTERY or damage to battery will result.

  • NEVER attempt to fully drain battery.

  • DO NOT store in unheated area with less than 50% charge on battery. Battery damage can occur.

  • Battery must be properly installed in unit to charge.

  • DO NOT turn on unit or attempt to operate unit while charging.

  • Keep battery cable clear of being pinched under battery when installing.

  • Check battery cover is firmly secured with both screws. Battery cover will be used to lift unit.