Battery Charger
Part# LS1070
Battery charger only works with the LS battery properly installed.
- When plugged into a unit with a low battery, the charger LED will turn red.
- Once the battery is fully charged, LED will turn green.
- Charging time will vary depending on the existing charge level of the battery.
FOR PROPER USE OF THE OSSIAN LS® BATTERY CHARGER, FOLLOW THE INSTRUCTIONS BELOW.
Fully Charge Battery Prior to First Use.
Recharge battery at end of each use for optimum performance.
-
Locate charging port on operator’s left side of rear battery compartment tower.
If necessary, remove liquid tank and raise orange cover to aid in accessing port. -
Plug round end of battery charger into charging port on battery tower.
-
Plug battery charger transformer into standard 110w outlet.
-
LED on transformer will turn red when battery is below a full charge.
-
LED on transformer will turn green when battery is fully charged.
-
When battery is fully charged, disconnect battery charger from charge port and close cover.
Push rear of cover down so that it fits snug over battery cover.
WARNINGS
Reinstall terminal covers on battery if disconnected for any reason.
DO NOT FREEZE BATTERY or damage to battery will result.
NEVER attempt to fully drain battery.
DO NOT store in unheated area with less than 50% charge on battery. Battery damage can occur.
Battery must be properly installed in unit to charge.
DO NOT turn on unit or attempt to operate unit while charging.
Keep battery cable clear of being pinched under battery when installing.
Check battery cover is firmly secured with both screws. Battery cover will be used to lift unit.